MS27647F
REQUIREMENTS:
1. MATERIAL: Rings: 52100 steel per AMS6440, or E52100 steel per FED-STD-66.
Balls: 52100 steel per AMS6440 or 51100 steel per AMS6449, or E51100 or E52100 steel per
FED-STD-66.
Seals: Polytetrafluoroethylene per AMS3652 or Polytetrafluoroethylene sheet, glass fabric reinforced per AMS3666.
Seal retainers: Any corrosion resistant steel.
2. LUBRICANT: MIL-G-81322 or MIL-G-23827, all bearings shall be packed with grease conforming to
MIL-G-81322 unless otherwise specified. If MIL-G-23827 is required, add the letter "L" after the
MS27647 dash number. MIL-G-23827 shall not be used for operation where temperatures exceed
250 F.
3. HARDNESS: Heat treat rings and balls to rockwell "C" 60 to 66 and stabilize for operation at 250 F.
4. SURFACE ROUGHNESS: Raceways and balls shall be 8 microinches Ra per ANSI/ASME B 46.1.
5. PLATING: All external surfaces except bore, seals and seal retainers shall be zinc nickel in accordance with AMS
2417, Type 2, or cadmium plated in accordance with QQ-P-416, Type I, Class 2, with a thickness of
.0003 to .0006 inches.
6. RADIAL INTERNAL CLEARASNCE: Without designator "R" part number indicates .0000 to .0010 with designator "R" part number indicates .0002 to .0005.
7. RADIAL ECCENTRICITY: Inner ring, .0010 max, outer ring, .0016 max.
8. LATERAL ECCENTRICITY: Inner ring, .0010 max, outer ring, .0016 max.
9. PART NUMBER: The part number shall be sequenced left to right with designations in the following sequence: EXAMPLE OF PART NUMBER:
MS27647 - 4 G R L = Bearing ball airframe, antifriction, extra wide, double row, intermediate duty, .2500 inch
Bore .6250 inches outside diameter .0002 to .0005 inches, Radial internal clearance with relubrication groove, filled 80% minimum with MIL-G-23827 lubricant, 250 F max.
Lubricant designator (see lubricant requirements)
Radial Internal Clearance Designator (see Radial Internal Clearance Requirements) Suffix "G" indicates lubricant groove
Dash number (see Table I)
Military Specification Sheet Number
NOTES:
1. Unless otherwise specified, all dimensions are in inches.
2. This specification takes precedence over any other documents referenced herein.
3. Referenced documents are the issues in effect at the date of invitation for bid.
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business